Concept 116 1.0 Mil Clear Polyester Removable Air Egress Print Mounting Film 54 Inches x 300 Feet

Concept® 116 is a double-coated pressure sensitive 1.0 mil clear polyester film with permanent adhesive on one side and a removable adhesive on the other side. Concept ® 116 has a 4.5 mil clear air egress PET liner printed with Remove to Expose Adhesive on the removable adhesive side. This air egress liner assures smooth bubble free application. The clear liner allows the graphics to be viewed after lamination with Concept ® 116. This product is designed for laminating thin flexible plastic films and papers commonly found in graphics for temporary application to glass. The permanent adhesive is protected by a 1.5 mil clear polyester liner. This clear mounting film can be laminated by the cold laminating process without the addition of heat.

Applications:   
Concept® 116 is designed to produce two sided decals using digital prints, screen printed and other printed images for application to glass. These decals are cleanly removable. In all cases the substrates must be clean and free of dust, dirt and oil. This product is not recommended for tinted or laminated windows. May be used on substrates other than glass but your specific application must be thoroughly tested before production.

Thickness:   
Carrier Film 0.9 to 1.0 mils
(Thickness variance +/- 10%)

Adhesive Thickness Side One:   
Adhesive 0.8 to 1.0 mils each side.
(Thickness variance +/- 10%)

Liner Thickness Side One:   
AP Liner 1.4 to 1.6 mils
(Thickness variance +/- 10%)

Adhesive Thickness Side Two:   
Adhesive 0.8 to 1.0 mils each side.
(Thickness variance +/- 10%)

Liner Thickness Side Two:   
Air Egress Liner 4.4 to 4.8 mils.
(Thickness variance +/- 10%)

Temperature Ranges:   
Minimum application temperature +40°F.
Service temperature range -40 °F to +180°F.

Expected Exterior Exposure:   
Removability of the removable adhesive from standard window glass is up to 6 months under normal exposure conditions.

Adhesion:  
 Removable Adhesive
(The adhesive was laminated to 2-mil polyester film before adhesion testing)
To glass: 12 to 40 oz. / in.
To standard test panels: 12 to 40 oz. / in.
When tested according to PSTC-101 Method A with a 24-hr. dwell at 70 °F and 50% relative humidity. Typical values. Individual values may vary. Test thoroughly before production.

Storage Stability:   
One (1) year shelf life when stored at 70 °F and 50% relative humidity.

Product Codes:  
 116-54 (54 x 150 Roll)